Trevor Sullivan's Tech Room

Minding the gap between administration and development

Posts Tagged ‘sccm sdk’

PowerShell: Report / Check the Size of ConfigMgr Task Sequences

Posted by Trevor Sullivan on 2012/01/10


Introduction

In Microsoft System Center Configuration Manager 2007 operating system deployment (OSD), there is a limitation of 4MB for task sequence XML data. This is discussed in a couple of locations:

The Technet document linked to above says the following:

Extremely large task sequences can exceed the 4-MB limit for the task sequence file size. If this limit is exceeded, an error is generated.

Solution: To check the task sequence file size, export the task sequence to a known location and check the size of the resulting .xml file.

Basically, the Technet troubleshooting article is suggesting that you would need to go into the ConfigMgr console, right-click a task sequence, export it to a XML file, and then pull up the file properties. That’s fine for one-off troubleshooting, but what if you had 1000 task sequences and needed to know how large all of them were? Read on to find out how!

Read the rest of this entry »

Posted in configmgr, powershell, scripting, wmi | Tagged: , , , , , , , , , , , , , , , , | 2 Comments »

ConfigMgr 2012: Deleting Advertisements

Posted by Trevor Sullivan on 2011/07/06


Where’d my Advertisements Go?

Advertisements aren’t quite what you think they are. At least, that’s probably the case if you’re talking in context of Microsoft System Center Configuration Manager (SCCM / ConfigMgr). At first glance you might see “deleting advertisements” and exclaim: “YES! Please do!” The difference here is that advertisements in SCCM are not product or service advertisements, but rather proclamations of the availability of software to a computer system. If you’re reading this, you most likely already knew that, but if not, then … now you do.

Back in the days of the SCCM 2007 console, there was a single Software Distribution –> Advertisements node which contained advertisements for both standard software distribution and operating system deployment (OSD) task sequences. This worked pretty well, but it was a little confusing since the operating system deployment node was entirely separate from software distribution. Hierarchically, it just didn’t make sense.

image

Read the rest of this entry »

Posted in configmgr, ConfigMgr vNext | Tagged: , , , , , , , , , , , , , , , , | Leave a Comment »